3D printed enclosures

Size

Each board comes in different sizes as described in the hardware page. Here are the 3D models for each size we've found so far. If you have found a model For P4 and P6 and you tested it, please open an issue and send some pictures.

P3 64x32 LED MATRIX

For the P3 size panel, I found this 3D model. 3D Printed Case.zip

I recommend only printing the housing and skipping the back part because it is too difficult to put it on and remove it. Instead, I removed the clips and I used a piece of plexiglass that fits perfectly.

P4 64x32 LED MATRIX

This is a great looking one that allow you to put the PSU bloc inside the case. https://cults3d.com/en/3d-model/various/led-matrix-case-p4-adafruit-64x32

P5 64x32 LED MATRIX

Thanks to Zach Levine for finding this one. There is this great tutorial on how to make an enclosure for the P5 here. If you are using a Pi Zero (which won't fit in the mount), there is this section on Howchoo which refer that tutorial but give an alternative.