Skip to content

How to use network scan

Jump to bottom
seriousm4x edited this page Aug 21, 2023 · 3 revisions

upsnap-scan

Requirements

  • Network scan needs nmap to be installed.
  • Put in the IP range of your local network (for example 192.168.0.0/24).
  • Nmap network scan needs admin/root privileges, so make sure to run UpSnap as admin/root.

Scanning

When you press the button UpSnap will scan your network (it might take some seconds). The results are shown below where you can easily add the found devices.

upsnap-scan-results

Clone this wiki locally