Add minimum flow rates for spiral vase transitsions #13329
+44
−6
Conversation
This file contains bidirectional Unicode text that may be interpreted or compiled differently than what appears below. To review, open the file in an editor that reveals hidden Unicode characters.
Learn more about bidirectional Unicode characters
Currently when starting the spiral vase the extrusion rate is ramped from 0 to 100% on the first layer and from 100% to 0% on the last layer. In some cases it can lead to underextrusion at the beginning and end of the spiral. This change adds minimum flow rate options for the beginning and the end of the vase. This means that instead of ramping from 0% to 100% it instead ramps from for example 20% to 100%. This issue has been reported in SuperSlicer but the same issue occurs in PrusaSlicer aswell. supermerill#4195
|
Here are also prints with the same values side by side. I trust you will figure out which is which. |
Sign up for free
to join this conversation on GitHub.
Already have an account?
Sign in to comment
Add this suggestion to a batch that can be applied as a single commit.
This suggestion is invalid because no changes were made to the code.
Suggestions cannot be applied while the pull request is closed.
Suggestions cannot be applied while viewing a subset of changes.
Only one suggestion per line can be applied in a batch.
Add this suggestion to a batch that can be applied as a single commit.
Applying suggestions on deleted lines is not supported.
You must change the existing code in this line in order to create a valid suggestion.
Outdated suggestions cannot be applied.
This suggestion has been applied or marked resolved.
Suggestions cannot be applied from pending reviews.
Suggestions cannot be applied on multi-line comments.
Suggestions cannot be applied while the pull request is queued to merge.
Suggestion cannot be applied right now. Please check back later.
Currently when starting the spiral vase the extrusion rate is ramped from 0 to 100% on the first layer and from 100% to 0% on the last layer. In some cases it can lead to underextrusion at the beginning and end of the spiral.
This change adds minimum flow rate options for the beginning and the end of the vase. This means that instead of ramping from 0% to 100% it instead ramps from for example 20% to 100%.
This issue has been reported in SuperSlicer but the same issue occurs in PrusaSlicer aswell.
supermerill#4195
The behaviour of this feature can be tested by viewing the volumetric flow rate of a flow-rate limited slice. Here are two screenshots one with the existing 0% starting points and one with 70% and 40% starting points on the start and end of the spiral.