Version 1.4.1 (2015/12/15) Corrected problem in error trapping routine: did not display the correct information.
Version 1.4 (2015/12/09) Added support for use of a TCP port to communicate with the Gateway. This allows the gateway to be connected anywhere on the network using a Device Server (such as the Lantronix UDS-1000) or a PC with a "Serial to Ip" software running (such as the free Serial-TCP program)
=============================================================== Version 1.2 (2015/11/14) Added command line support for unattended mode: 4 parameters are required: ,,,
Ex: MoteinoWirelessProgramming 6,115200,5,c:\Arduino\Hexfiles\MyHexfile.HEX This would launch the program in minimized mode, using COM port #6 at 115200 baud, and transmitting file "c:\Arduino\Hexfiles\MyHexfile.HEX"
The program will automatically exit when finished with the following return codes that can be read from a .BAT or .CMD file for automatic processing. Code Description 0 Success 20 Cannot open COM port 30 Cannot set Target on Gateway 40 Handshake NAK (Image refused by target) 50 Problem in processing HEX file 60 HEX file not found
=============================================================== Version 1.1 (2015/11/02) Saves/reads last HEX file used in MoteinoWP.ini file
=============================================================== Version 1.0 Initial release