WARNING: Tip temperature measurement is still unreliable, this firmware might heat up your iron far above the temperature on display. Use with caution and at own risk!
This is a fork and first attempt to get the firmare of ptdreamer working on a slightly different STM32 soldering controller. See schematic/Ver2.1S/ for hardware details
Working:
- OLED Display
- Rotary Encoder
- Buzzer
- Wake switch
- Supply voltage sensor
- Ambient temperature sensor (might need calibration)
- Tip temperature read out (might also need calibration)
- T12 PWM Control (might burn your tip)
TODO:
- I2C eeprom
Custom firmware for the chinese kseger soldering iron controller
Check http://www.ptdreamer.com/chinese-stm32-oled-soldering-controller-reverse-engineer-custom-firmware/ for more information