Smart Lamp with HomeKit integration. All written in Swift.

This project contains three parts:

1. LED Control client for iOS
2. LED Server running on Raspberry Pi
3. Homebridge config

Install Raspbian

On the Raspberry PI you must run Raspbian and connecting to your local network.

Install Swift

First step is to install Swift by adding the swift-arm repo:

curl -s "https://packagecloud.io/install/repositories/swift-arm/release/script.deb.sh"| sudo bash

Followed by installing Swift itself.

sudo apt-get install swift5

Install Homebridge

For that just follow the official installation guide for Raspberry Pis.

You have to add a new accessory. Therefore, cop that part from the homebridge-config of this repo.

Run the Server

• clone this repo to your Raspberry Pi
• go into the LED-Server sub-folder
• build the swift project: swift build
• now the binary has been created
• I recommend to create a linux service and run the binary on startup.

Connecting hardware

I bought a cheap WS2812B LED strip on Aliexpress. It has three connectors.

• Connect the data pin of your LED strip to GPIO18. This is needed because this is the pin which supports PWM.
• The ground connector must be connected to any of the ground pins of the Raspberry Pi.
• The third connector of the LED strip is for power supply. Connect it to one of the 5V pins of your Raspberry PI.

Control your light

Afterwards you should be able to control your lamp either via Homekit, including Siri and from the small iOS application Raspberry PI LED Controller which is also part of this repo.

Remarks

I am using a Raspberry Pi Zero. If you are using a different model, you need to change the LED.swift file accordingly in the 'LED Server' part of the repo.