A tool that helps makers and professionals level their FDM-based 3D Print Bed
Do you ever find it a hassle to manually level your 3D print bed every time you make a print? Even seasoned 3D printing pros need to level the printbed after every couple prints. We’ve created a device that helps tremendously improve this procedure. This project, codenamed OmniLevel, helps you level your 3D printer bed with just a push of a button. We used the M5Stick-C to monitor the pressure between the nozzle of an extruder and the printer bed. Using a force sensitive resistor (FSR), this allows the user to easily detect when the bed is level.
Want to build it? Read the full Instructable!
For this project, you will need the following materials:
- M5StickC - $25 on Amazon
- Male 8-pin header - $1 at Parts store or salvaged
- Round Force-Sensitive Resistor (FSR sensor) - $7 on Adafruit
- 10k Ohm Resistor - $0.50 at Parts store or salvaged
Overall, it should cost you less than $40 to build.
It is highly recommended that you have the following supplies:
- Wire Strippers/Cutter
- Soldering iron w/ solder
- Tweezers
- Hot glue or UV glue (to isolate connections)
- A piece of large heat-shrink (to protect the circuit)
