This is a mounting unit for the LiteBeam series from Ubnt. Only tested with LiteBeam M5. Idea is to use a commercially available suction cup base and print a little arm with 2 additional degrees of freedom.
- all holes are for M5 screws
- use washers, if you have the big ones with 15mm outer diameter (e.g. DIN 9021)
- lots of infill (80% is okay)
- have a look at the layers before you print, you might have to activate support
- activate support
- activate "don't support bridges"
- pattern: pillars This should build a support only under the screw hole in the middle of the part.