FPGA Ethernet UDP Transmitter

This project creates a module that can be used to interface with an Ethernet PHY for transmitting UDP packets. Only transmission is supported, and there is no receiver implemented on the FPGA.

The module is built specifically for streaming fixed width data from the FPGA. For example, the module works well for streaming data sampled on an ADC or data generated by some process. Though the module can somewhat handle variable sized data, it is not directly supported. To send variable sized data, each data point must be padded to the size of the largest data point to be sent. The size of the data points must be declared up front and the module guarantees that a single data point will never be fragmented accross multiple packets.

This project was specifically built for and tested on the Digilent Arty A7, which uses a Xilinx Artix-7 XC7A100T FPGA and has a Texas Instruments DP83848J Ethernet PHY controller. However, the MII standard will work with any PHY.

Will this work in my project?

You should use this module if

You need high-speed data transfer over Ethernet/UDP
The data to be sent is all the same size
You need to assign the the FPGA specific IP, MAC, and port addresses

You should not use this module if

You need a high reliability connection based protocol like TCP
You need the FPGA to receive packets
You need DHCP

Using in a Project

To use this module in a project, there are two files that must be included

src/hdl/eth_udp.sv
src/ip/eth_udp_fifo_async/eth_udp_fifo_async.xci

The ethernet_udp_transmit module is to be instantiated, and it internally uses the eth_udp_fifo_async IP.

If the Xilinx IP is locked, then it is likely that the IP was configured for a different part. Check this by running report_ip_status in the Tcl console, and the fix is to run upgrade_ip [get_ips *].

Building the HDL

Open Xilinx Vivado and select Tools > Run Tcl Script..., then select the generate_project.tcl script in the file exporer. The script will run and produce the Vivado project in a new proj/ directory by importing all of the project sources. If the project fails to be created, it is most likely that the proj/ directory already exists.

Testing

The project can be tested using the the ether_tester program. The tester generates a pseudo-random sequence of bytes on the FPGA to send over UDP, and the test program verifies that the sequence it receives is correct.

To use the test program, make sure that Cargo is installed for compiling Rust programs, then navigate to the ether_tester directory and run

cargo build

to download dependencies and build the project. To view the program help information, run

cargo run -- -h

A sample invocation of the program is

cargo run --                              \
    -b256                                 \
    --serial-port=/dev/ttyUSB1:115200     \
    --src=8.8.8.8:4096,aa:bb:cc:dd:ee:ff  \
    --dest=1.2.3.4:4096,00:11:22:33:44:55 \
    -r1000

In order, the arguments mean the following.

Generate UDP packets with 256 bytes of data. This depends on the configuration of the FPGA.
Set the serial port and baudrate to use. The baudrate depends on the FPGA configuration.
Set the IP address, port number, and MAC address of the FPGA. These are dynamic and can be changed at any time. They do not depend on the FPGA configuration.
Set the IP address, port number, and MAC address of the host to receive packets from the FPGA.
Perform 1000 tests.

License

adamchristiansen/fpga-ethernet-udp

ErrorLooks like something went wrong!

About

Topics

Resources

License

Uh oh!

Stars

Watchers

Forks

Releases

Packages 0

Uh oh!

Contributors 2

Languages

Error
Looks like something went wrong!

Packages