How I set up my system from scratch.
GNU Stow is used to symlink files to the $HOME directory.
Ensure you have the following installed on your system
sudo apt install git
sudo apt-get update
sudo apt-get install -y ansible
Naviagte to your root directory and clone the repo
cd $HOME
git clone https://github.com/abdullahmorrison/dotfiles.git
cd dotfiles
Run Ansible playbook to install all required libraries
ansible-playbook .bootstrap/setup.yml --ask-become-pass
then use GNU stow to create the symlinks
stow .
To set up your .zshrc config & aliases run the following cmd
source $HOME/.zshrc
gh was installed through the ansible playbook. Set up your git authentication by running the following command.
gh auth login
after answering the questions given, you will recieve an auth code. Insert the given code to github.com/login/device
open tmux and run the following to set up keybinding and settings
tmux source ~/.config/tmux/tmux.conf
then navigate to the tmux.conf file and run <prefix>-I to install tmux themes and dependencies
cd ~/.config/tmux/tmux.conf
go to https://github.com/abdullahmorrison/nvim to view setup
Install submodules with the following commands
git submodule init
git submodule update
run the following command if you already have some file in your $HOME dir that is in your .dotfiles.
stow --adopt .
This moves any conflicting files to the .dotfiles directory