Skip to content

A repo for an EMG/EEG project for the final project in the electronics course.

License

Notifications You must be signed in to change notification settings

Y-Akihiro/EMG-EEG

Folders and files

NameName
Last commit message
Last commit date

Latest commit

 

History

10 Commits
 
 
 
 
 
 
 
 

Repository files navigation

EMG (EEG)

Repo for an EMG project that I did for the final project in the electronics course (PHYS-GA 1500, Electronics for Scientists).

Introduction

There are so many resources available to make one's own EMG (Electromyography) or EEG (Electroencephalography).

This is a record of an EMG (rather than EEG at this point, due to the sensitivity issue) based on the online references that I found in spring of 2020. The references are listed at the bottom of this page.

This is something I wanted to try and actually did for an electronics course final project. I will add/update the scripts and detailed design of the circuit later (TBA).

Parts list/BoM

  • Arduino
  • Electrodes
  • Electronics parts (resistor, capacitor, INA, etc.)

Design/Software

The PCB board consists of the following parts:

  1. Over-voltage protection
  2. INA
  3. Notch filter
  4. high-pass filter and variable gain
  5. low-pass filter
  6. Right-leg drive
  7. -5Vdc circuit
  8. DC offset

design

(FYI: This circuit is the initial design and not fully functional when tested. I will update the working model.)

References

About

A repo for an EMG/EEG project for the final project in the electronics course.

Resources

License

Stars

Watchers

Forks

Releases

No releases published

Packages

No packages published