A vl53l5cx library for esp32 using the esp-idf framework. This library is based on ST's Ultra Lite Driver (ULD) for VL53L5CX v1.3.11 . This library is just an adaptation of the ST's library for esp-32.
Warning This Library is not compatible with Arduino framework
For the examples this is the used wiring, but feel free to modify it and adapt it for your needs.
| VL53L5CX-SATEL Pins | ESP32S3 Pins |
|---|---|
| INT | NC |
| I2C_RST | NC |
| SDA | GPIO1, 2.2 kΞ© pullup resistor required to 3v3 |
| SCL | GPIO2, 2.2 kΞ© pullup resistor required to 3v3 |
| LPn | 3V3 |
| PWREN | NC |
| AVDD | 3V3 |
| IOVDD | 3V3 |
| GND | GND |
The library is available at https://components.espressif.com/components/rjrp44/vl53l5cx.
So, you can use the IDF Component Manager to easily import this library into your project. To add this component to your project, run:
idf.py add-dependency "rjrp44/vl53l5cx^2.0.4"
You can find in π ./examples ST's examples adapted for ESP32 with IΒ²C. For more information about the available features read UM2884.
If by running an example you get a stack overflow error, this means that your main stack size is too small.
***ERROR*** A stack overflow in task main has been detected.
Increase the main stack size :
Run idf.py menuconfig. Go to Component Component config -> ESP System settings and increase the Main task stack size to at least 7168.
In order to get more control over your sensor configuration, run idf.py menuconfig and go to Component Config -> Vl53l5cx.
Copyright Β© 2024 RJRP.
This project is BSD 3-Clause licensed.
Give a βοΈ if this project helped you!