Settings
Settings are found at /mnt/WRdisk/settings.txt.
The /mnt/WRdisk/ location is the only folder which can be written even with the overlay function active. All the other folders will not hold their data after a reboot. See the overlay item for more information.
👉 Because the settings are loaded during booting, changes will not take effect until you restart the YoloCam.
You have the following settings:
| Setting | GPIO | Default | Description | |
|---|---|---|---|---|
| [Section1] | ✔️ | ✔️ | Identifier, don't change. | |
| cam_name | ✔️ | name_ID | The camera ID will appear in your emails (in case you have more cameras active). | |
| ✔️ | none | Your personal e-mail address where the e-mails will be sent. None disables email notifications. |
||
| gmail | ✔️ | [email protected] | Your Gmail account is used for storage and re-directing emails. | |
| recording | ✔️ | 1 |
1 enables recording, 0 disables recording. |
|
| rec_prolong | ✔️ | 10 | Extends the recording by x seconds after an event.It avoids a succession of tiny recordings: the postman rings - the postman leaves (to check the back door) - the postman comes back on the scene (no one at the back door) - the postman leaves (writes a note in his car) - the postman comes back - and so on. |
|
| rec_max_time | ✔️ | 3600 | Maximum duration of a recording in seconds. Zero (0) disables the limitation. | |
| no_sec_mail | ✔️ | 90 | After an email is sent, no second email within x seconds.(No need for an avalanche of emails once your kid has let the dog loose in the backyard). |
|
| gdrive | ✔️ | 1 |
1 enables Gdrive storage, 0 disables storage. |
|
| up_and_del | ✔️ | 1 |
1 deletes a recording from the Raspberry Pi (SD card or USB stick) once uploaded to Gdrive. Recordings are temporarily stored in /dev/shm/rec/. Highly recommended!0 saves all recordings in /home/pi/Videos. Stops recording when 95% of the available memory is used, to prevent your Raspberry PI from crashing due to memory shortage. |
|
| print_out | ✔️ | ✔️ | 1 |
1 prints the detected objects on the terminal screen, 0 disables printing. |
| show_out | ✔️ | ✔️ | 1 |
1 shows camera recording with objects on Rpi, 0 hides the window. |
| guard_temp | ✔️ | ✔️ | 1 |
1 activates overheating protection (above 75 °C, fewer frames are analyzed), '0' disables protection. |
| mjpeg_port | ✔️ | 0 | Port number for remote viewing with a browser in your network.0 disables the function. |
|
| alive | ✔️ | ✔️ | 1 |
1 enables software watchdog. Highly recommended! 0 disables the watchdog. |