Instructions
- Run MC from desktop (if not running)
- Plug in printer (wait for driver to install if required)
- Select correct profile from printer drop down list for connected printer
- Click edit (pencil) icon to right of selected profile
- Set the com port to the plugged in printer
- Click 'Done'
- Click 'Settings & Controls'
- Click 'Controls' tab
- Scroll to the bottom of the panel and click 'Change'
- Select 'PreFlashFirmware.hex' and click 'Open'
- After firmware is done installing
- Connect
- Click 'Update' to install correct firmware
- Connect
- Home X (reverse motors if required)
- Home Y (reverse motors if required)
- Home Z (reverse motors if required)
- Ensure Extruder and Bed (if available) temps are close to 35 c
- Heat extruder (ensure heating)
- Heat Bed (if available) ensure heating