The firmware for the LeoCore controller running inside Leo Rover.
The main functionalities include:
- velocity commands for the robot,
- velocity and PWM commands for individual wheels,
- battery voltage feedback,
- wheel states (position, velocity, torque, PWM duty) feedback,
- odometry feedback (calculated from wheel encoders),
- feedback from the IMU sensor.
The project is written for PlatformIO and uses the STM32Cube embedded software libraries. The low-level code is generated by the STM32CubeMX tool.
The firmware also uses rosserial client library to expose its functionalities on ROS topics, services and parameters. For the documentation of the ROS API, visit leo_fw on the ROS wiki.
To build the project, all you'll need is Visual Studio Code with the PlatformIO IDE extension.
To change the STM32CubeMX configuration, you will also need the stm32pio tool in order to properly regenerate the code.
Open the project in PlatformIO IDE, then run the PlatformIO: Build task.
Connect the ST-Link to the pins on the LeoCore debug pin header, then run the PlatformIO: Upload task.
You can also run the GDB debugger by running the PIO Debug launch configuration (or just clicking F5).
Upload the .pio/build/genericSTM32F401RC/firmware.bin to Leo Rover, then, on the robot, run:
rosrun leo_fw flash firmware.bin
Open the leocore.ioc project in STM32CubeMX, make the changes and save the project.
Don't click GENERATE CODE. Instead, type:
stm32pio generate
The current configuration assumes that STM32CubeMX is installed under /opt/STM32CubeMX. You can change the path in the stm32pio.ini file.
