Added touch flip flags to TFT_eSPI driver.

[tpitman]

I don't know if this is the right way to do this, but it is the way that works for me. I am creating this pull request knowing full well that you might come up with a better way. I need the touch to be rotated independent of the screen graphics and don't see a way to do one without the other. So adding these flags lets me rotate just the touch input.

[ImpulseAdventure]

Hi Tony — in general, the calibration was supposed to take care of the display vs touch orientation so it is interesting to find a case where we need an additional flip setting. It could very well be needed!

Just so that I understand your particular device setup and rule out any calibration issues, can you confirm the following:

• Which touch driver are you using?
• If it was a resistive touch panel, can you attach the output of the diag_ard_touch_calib calibration sketch?

Thanks!

[tpitman]

I am using the FT6236 hardware and I have the FT6206 selected in the configuration files. My screen is not rotated at all, but both x and y are flipped.

…

On Tue, Aug 25, 2020 at 10:20 PM Calvin Hass ***@***.***> wrote: Hi Tony — in general, the calibration was supposed to take care of the display vs touch orientation so it is interesting to find a case where we need an additional flip setting. It could very well be needed! Just so that I understand your particular device setup and rule out any calibration issues, can you confirm the following: - Which touch driver are you using? - If it was a resistive touch panel, can you attach the output of the *diag_ard_touch_calib* calibration sketch? Thanks! — You are receiving this because you authored the thread. Reply to this email directly, view it on GitHub <#249 (comment)>, or unsubscribe <https://github.com/notifications/unsubscribe-auth/AAWFTQ7IG45Z6U76X7EWMXLSCSESVANCNFSM4QLGWBRQ> .

[ImpulseAdventure]

Thanks Tony... yes, we might need to apply some additional options to support your particular capacitive display.

Could you run the following test for me?

• Load examples/arduino/diag_ard_touch_calib
• Modify (~ line 40): Comment out the #error Calibration only supported...
• Modify (~ line 199): Change DET_RAW_RANGE_MIN to 150
• Run the first 5 steps of the calibration (pressing on each cross-hair)
• Please paste or attach the serial monitor output to this issue

Thanks!

[ImpulseAdventure]

Hi @tpitman — we can certainly add the ability to flip the capacitive touch orientations, much like you had proposed here.

The reason for my test request in #249 (comment) was to see if we can utilize the existing calibration sketch to detect the orientation settings automatically.

Thanks

[tpitman]

Sorry this is taking so long. Just got a lot going on and this is one project of many. I know you understand because you are in the same boat.

…

On Tue, Oct 20, 2020 at 8:13 AM Calvin Hass ***@***.***> wrote: Hi @tpitman <https://github.com/tpitman> — we can certainly add the ability to flip the capacitive touch orientations, much like you had proposed here. The reason for my test request in #249 (comment) <#249 (comment)> was to see if we can utilize the existing calibration sketch to detect the orientation settings automatically. Thanks — You are receiving this because you were mentioned. Reply to this email directly, view it on GitHub <#249 (comment)>, or unsubscribe <https://github.com/notifications/unsubscribe-auth/AAWFTQ5HRHDWN3JQG2QRDN3SLWLIBANCNFSM4QLGWBRQ> .