Arduino fan controller

Features

Control fan speeds by using the following modes:
- Auto: Use temperature->speed curves for each fan
- Low: All fans sets to their lowest value on the curve (that is not 0)
- High: All fans to their highest value on the curve (that is not 100)
- Full: All fans to 100%
SSD1306 Display:
- Fan speed control mode
- Sensor temperature
- Fan speeds percent (with RPM if tachometer is available)
Buzzer:
- When there is no display: beep to transmit control mode and temperature
- Beep when temperature is critical
Warning led: Blink when in low speed mode (as temperature may rise)
Button:
- Short button press
  - Send control mode, temperatures and fan speeds to serial output
  - Beep first temperature (mix of morse and roman numbers)
    - .: 1, ..: 2, ...: 3, .-: 4, -: 5, -.: 6, -..: 7, -...: 8, .--: 9, --: 0
- Long button press: Switch fan control modes
  - Auto (beep .-, morse code for A)
  - Low (beep .-.., morse code for L)
  - High (beep ...., morse code for H)
  - Full (beep ..-., morse code for F)

Install dependencies
- On GNU/Linux platforms, execute ./arduino-install-libs.sh
- On Windows platform, using the Arduino Library manager, install the following libraries:
  - ssd1306 by Alexey Dynda
Edit config.cpp to configure the different settings:
- Pinout
- Sensor list: pin
- Fan list: pin, speed curve, associated sensor
- SSD1306 display connection
- ...

Perfboard design & photos in board/

Name		Name	Last commit message	Last commit date
Latest commit History 34 Commits
board		board
.gitignore		.gitignore
LICENCE		LICENCE
README.md		README.md
arduino-install-libs.sh		arduino-install-libs.sh
buzzer.cpp		buzzer.cpp
buzzer.h		buzzer.h
config.cpp		config.cpp
config.h		config.h
custom.h		custom.h
display.cpp		display.cpp
display.h		display.h
fan-controller.ino		fan-controller.ino
fan.cpp		fan.cpp
fan.h		fan.h
sensor.cpp		sensor.cpp
sensor.h		sensor.h