question about wire placement...

[pleasantone]

Solder the wires to pass on the opposite side of the antenna to prevent interference with NFC reception. The antenna is the thick white line around the board (note that the photo does not follow this guideline).

I took this to mean "solder the wires through the back (non-chip-side) of the board" but I see in your build photos that you brought the wires across/over the antenna. Was that just a mistake in your early build or do you suggest coming in on the chip-side as in the photos?

Great work btw!

[yanshay]

Thanks!

Yes, I didn't think of it when I started. It's better not to interfere with the reception though not a big deal.

[pleasantone]

Thanks for the clarification!

…

On Apr 7, 2025 at 4:07 PM -0700, yanshay ***@***.***>, wrote: Thanks! Yes, I didn't think of it when I started. It's better not to interfere with the reception though not a big deal. — Reply to this email directly, view it on GitHub, or unsubscribe. You are receiving this because you authored the thread.Message ID: ***@***.***>

[yanshay]

BTW - there seem to be some issue with 0.2.1 so install the previous version 0.1.12 for now. Try the latest version only when you see it's 0.2.2 or above.

[yanshay]

Version 0.2.2 is out, so you are good to do and use that one.

[pleasantone]

Awesome, updated, using it now, working great, thank you! I tried to 5* your model but I made the mistake of printing it with OrcaSlicer in LAN mode so ML doesn't seem to want me to do so. Sorry.

…

On Apr 8, 2025 at 2:15 AM -0700, yanshay ***@***.***>, wrote: Version 0.2.2 is out, so you are good to do and use that one. — Reply to this email directly, view it on GitHub, or unsubscribe. You are receiving this because you authored the thread.Message ID: ***@***.***>