New issue

Have a question about this project? Sign up for a free GitHub account to open an issue and contact its maintainers and the community.

Sign up for GitHub

By clicking “Sign up for GitHub”, you agree to our terms of service and privacy statement. We’ll occasionally send you account related emails.

Already on GitHub? Sign in to your account

Jump to bottom

XDS connector update and pre-test necessary #28

Open

gituser789 opened this issue Jan 13, 2025 · 0 comments

Contributor

gituser789 commented Jan 13, 2025

The pin header for external debugger connection should be more robust and proof against twist (wrong connector direction).

look on the internet for XDS500 and XDS1000 debugger, and check common connectors
See if the are twist-proof and may add the connector

Next, a pre-investigation is necessary:

small lab setup, and see if external debugger can be used in general. Also check, if external debugger is more robust than internal one. There must be an XDS200 somewhere in the lab.
See if any disconnection of on-board XDS100 debugger is necessary if external one is used
if yes, add a switch on the PCB what can disconnect the on-board debugger easily

Sign up for free to join this conversation on GitHub. Already have an account? Sign in to comment