Increased printing time

[Akyna]

Description

After updating to this version "^4.2.0" from "^3.1.1" we noticed that printing time increased at least twice.
Moreover, sometimes it could take even 3 times more in time.

So for version `"^3.1.1"`` it's always permanent for ~ 4-6 seconds (we are printing the image as a source of trues)

But for version `"^4.2.0"`` it started from 7-8 seconds, then could take 16 - 18 sec.

We deleted a printer from connected devices -- restarted the printer -- reloaded the device ---> time is reduced for 6-8 sec.

But then it was increased again for 1-3 seconds.
So it's difficult to decide about the printing time.
Could you perform some test cases on your side? Thx in advance

Steps to reproduce

• install the last version
• Test print some images (not large )

react-native-esc-pos-printer version

4.2.0

React Native version

0.75.3

Platforms

iOS

Workflow

React Native

Architecture

Fabric (New Architecture)

Build type

Debug app & production bundle

Device

Real device

Device model

iPad PRO (11-inch 2nd generation) (18.0)

Acknowledgements

Yes

[tr3v3r]

It would be grate if you could give me reproducible demo

[Akyna]

It would be grate if you could give me reproducible demo

What exactly do you need - a video record?
Pls, lemme know - I'll prepare for you the data
Cuz our project is under NDA - I can provide only 'printing' part ))

[tr3v3r]

The minimal code to reproduce. Ideally you can create clean project with simple print job and upload to github

[Akyna]

The minimal code to reproduce. Ideally you can create clean project with simple print job and upload to github

Sure, np
But, will do it tomorrow - today was a loooong day ))

[Akyna]

The minimal code to reproduce. Ideally you can create clean project with simple print job and upload to github

Done

[Akyna]

@tr3v3r hi!
Any updates?

[tr3v3r]

Hello, not yet sorry. Just a kind reminder that it is an open-source project and can contribute to it only at my spare time. пн, 21 окт. 2024 г. в 10:21, Andrii Boiko ***@***.***>:

…

@tr3v3r <https://github.com/tr3v3r> hi! Any updates? — Reply to this email directly, view it on GitHub <#184 (comment)>, or unsubscribe <https://github.com/notifications/unsubscribe-auth/AFVAA3WCIZNBGETZONWCN3LZ4S2QHAVCNFSM6AAAAABPGH74MGVHI2DSMVQWIX3LMV43OSLTON2WKQ3PNVWWK3TUHMZDIMRVHE2TKNZUHE> . You are receiving this because you were mentioned.Message ID: ***@***.***>