Expected sizes for mcu/plate/case & DXF for plate? (Pretty please)

[alist]

Hi thank you so much for this project!!

Struggling a bit with the SVGs under case/ as when I upload them to a Sculpteo, they seem to be detected at the 4x the true size, as you warned about.

Would you be willing to add the "expected" sizes for the mcu/plate/case as a cross-check?

SVGs for the plates and MCU shield can be found in case/. These are sized in millimeters, so double-check when you order that you aren’t paying for something four times the size you need, as some cutting services assume the image is sized such that 1px == 1mm. I had SendCutSend cut the top plate out of .048” 304 stainless steel, which fits Kailh Choc (PG1350) switches perfectly. Sculpteo cut the MCU shield out of 1mm acrylic which turned out just fine.

I'm also wondering if you'd be willing upload a plate DXF as sendcutsend doesn't support svg and some svg-dxf converters are making mistakes. 😬

First home keeb, and am really looking forward to using this board while on the road.
Thank you so much again!