Install the board pack in Arduino IDE: esp32 from espressif
Set the board to: WEMOS LOLIN 32 Baud rate: 115200
Connect to the wifi: 'Knife Sharpner'
Browse to: 192.168.1.1
- - make app not sleep
- - move beep down 200 db
- - stop beep after round of sharpening, eg: raised X by x amound - add a sensor stop of 500ms after this detection. since this is only triggered from x accel, which is only the start of the return movement.
- - make main page number reset to 0 after hitting TARE (eg: show only deviation on main page)
- - level table button - TARE
- - preset angles
- - web server to see angles.
- - history of set angles