Filter "Hide receivers from the map" and "Hide chase cars from the map" do not work while maps stays open for longer time.

[Torrehoradada]

Hi, this is an issue which may have a reference to issue #267 which is already closed.
If you have one or both of those mentioned filters set, these items are initially not displayed on the map. If you now leave the map open for a while, during the time more and more of the filtered items will reappear.

You can remove those items from the map by setting the filter off and setting the filter on again. Sometimes -I do not know why- you need to repeat this one time to see a change on the map display.
If you now again wait long enough, the filtered items will repeat to reappear.
Greetings!

[darksidelemm]

Currently away in a location with poor internet access so cannot verify what's going on here.
Will have a look when I return in a few weeks..

[Torrehoradada]

Still the same, the error occures on following filters:

• Hide receivers from the map
• Hide recovered sondes from the map
• Hide chase cars from the map
  Also there is an error with "Only show visible on sidebar" which -when switched on- initially always displays one sonde which is outside of the view area. Moving around that area will eventually remove this one.

[darksidelemm]

I can confirm I've seen the behaviour of new receivers showing up after they have been 'hidden'. This is likely due to the websockets handling code not respecting those settings. I'm sure its the case for the other settings too (recovered sondes, chase cars).

I'll have some time to look into this over the next week or so.

[darksidelemm]

Hmm, this is an odd one. When those toggles are set, it certainly should clear all existing items off the map, then inhibit any new items from being showed. Will require more investigation...