-
|
Why do I do not see any dose inside the phantom? How do I have to change my data? |
Beta Was this translation helpful? Give feedback.
Replies: 3 comments 1 reply
-
|
The phantom could be defined incorrectly, for example if the CT ramp used to convert from DICOM to egsphant format was not valid. Or, maybe the ECUT is set high accidentally. If you can switch for a phantom created by dosxyz_gui while holding all the other settings the same, and the simulation looks better, then it is probably an issue with the phantom and the ctcreate process. |
Beta Was this translation helpful? Give feedback.
-
|
Dear Dr. Townson,
thans for your answer.
I have fixed the problems.
Best regards
Kirsten Galonske
Am Fr., 29. Sept. 2023 um 18:20 Uhr schrieb Reid Townson <
***@***.***>:
… The phantom could be defined incorrectly, for example if the CT ramp used
to convert from DICOM to egsphant format was not valid. Or, maybe the ECUT
is set high accidentally. If you can switch for a phantom created by
dosxyz_gui while holding all the other settings the same, and the
simulation looks better, then it is probably an issue with the phantom and
the ctcreate process.
—
Reply to this email directly, view it on GitHub
<#1063 (comment)>,
or unsubscribe
<https://github.com/notifications/unsubscribe-auth/BC2XHZDY6HLNLLC6U7BKT3LX43YLFANCNFSM6AAAAAA5H4W6ZI>
.
You are receiving this because you authored the thread.Message ID:
***@***.***>
|
Beta Was this translation helpful? Give feedback.
-
|
Do you mind sharing the solution, so that others can learn from it? Thanks! |
Beta Was this translation helpful? Give feedback.
-
|
Yes, of course. |
Beta Was this translation helpful? Give feedback.
Yes, of course.
I had to uncheck the "Howafarless" -Button.