This guide explains how to access U-Boot Menuconfig and save the resulting .config
file to the meta-bare-metal-router
layer, specifically in the recipes-bsp/u-boot/files
directory.
To start U-Boot Menuconfig, use the following command:
./menuconfig.sh --u-boot
Navigating the menuconfig
screen involves using the arrow keys, Enter, and Esc. Here are the basic steps for navigating and configuring U-Boot:
-
Boot Options
- Navigate to:
Top Level Menu -> Boot options
- Configure boot delays, autoboot commands, and other boot-related options.
- Navigate to:
-
Device Drivers
- Navigate to:
Top Level Menu -> Device Drivers
- Enable and configure various device drivers required for your hardware platform, such as Ethernet, USB, and MMC.
- Navigate to:
-
Network Support
- Navigate to:
Top Level Menu -> Network support
- Configure network settings, including IP addresses, DHCP, and network protocols.
- Navigate to:
-
Console and Terminal Settings
- Navigate to:
Top Level Menu -> Console configuration
- Set up console parameters such as baud rate, UART ports, and console devices.
- Navigate to:
-
Environment Settings
- Navigate to:
Top Level Menu -> Environment settings
- Manage environment variables, storage locations for environment data, and default environment settings.
- Navigate to:
-
Security Settings
- Navigate to:
Top Level Menu -> Security settings
- Enable security features such as secure boot, encryption, and authentication mechanisms.
- Navigate to:
-
General Setup
- Navigate to:
Top Level Menu -> General setup
- General system configurations such as default memory addresses and hardware timers.
- Navigate to:
Once you have configured U-Boot, the menuconfig.sh --u-boot
script will save a copy of the .config
file to recipes-bsp/u-boot/files/.config
.
-
- This script is used to launch the U-Boot
menuconfig
.
- This script is used to launch the U-Boot
-
Location of new U-Boot recepie
- This file is used to append the U-Boot recipe to the Yocto build process
-
Location of new U-Boot .config
- The
.config
file generated by themenuconfig
is saved in themeta-bare-metal-router/recipes-bsp/u-boot/files
directory.
- The
- Save Configuration: After making changes in Menuconfig, make sure to save your new U-Boot configuration. You can save it to the default
.config
file or specify a different filename. - Build U-Boot: Once the configuration is saved, build U-Boot using your build system (e.g.,
bitbake
for Yocto). Make sure to deploy the new U-Boot binary to your target device. - Documentation: Refer to the U-Boot Documentation for detailed instructions and advanced configurations.
By following these steps, you can customize U-Boot to support your specific hardware, ensuring optimal performance and compatibility for your embedded system.