The CC1352R1 LaunchPad board contains a TI CC1352R1 device.
- Detailed documentation for this target reference can be found here.
- Instructions on how to flash the CC1352R1 LaunchPad can be found here
- For any examples that use LEDs, make sure the LED's jumper settings are closed.
The following table lists the Board names of the resources used by the driver examples, and their corresponding pins. Note that there may be other resources configured in the board files that are not used by any driver example. Only the example resources are listed in the table.
| Board Resource | Pin |
|---|---|
Board_ADC0 |
DIO23 |
Board_ADC1 |
DIO24 |
Board_ADCBUF0CHANNEL0 |
DIO23 |
Board_GPIO_BUTTON0 |
DIO15 |
Board_GPIO_BUTTON1 |
DIO14 |
Board_GPIO_LED0 |
DIO6 (Red - must be jumpered) |
Board_GPIO_LED1 |
DIO7 (Green - must be jumpered) |
Board_I2C_TMP |
DIO4 - SCL, DIO5 - SDA |
Board_PIN_LED0 |
DIO6 (Red - must be jumpered) |
Board_PIN_LED1 |
DIO7 (Green - must be jumpered) |
Board_PIN_LED2 |
DIO6 (Red - must be jumpered) |
Board_PIN_BUTTON0 |
DIO13 |
Board_PIN_BUTTON1 |
DIO14 |
Board_PWM0 |
DIO6 |
Board_PWM1 |
DIO7 |
Board_SD0 |
DIO8 - MISO, DIO9 - MOSI, DIO10 - CLK, DIO21 - CS |
Board_SPI0 |
DIO8, DIO9, DIO10, DIO11 |
Board_SPI_MASTER |
DIO8 - MISO, DIO9 - MOSI, DIO10 - CLK, DIO11 - CS |
Board_SPI_SLAVE |
DIO8 - MISO, DIO9 - MOSI, DIO10 - CLK, DIO11 - CS |
Board_SPI_MASTER_READY |
DIO15 |
Board_SPI_SLAVE_READY |
DIO21 |
Board_UART0 |
DIO12 - RX, DIO13 - TX |
The current build is set to add support for single-precision floating point.
Meaning that System.Math API supports only the float overloads. The double ones will throw a NotImplementedException.
Because this CPU has a proprietary boot mechanism it does use nanoBooter.
Follow the instructions here on how to flash nanoCLR image in the board.