README.md

SocketCan - CAN BUS library (Linux only)

Controller Area Network Protocol Family bindings (SocketCAN).

Documentation

• SocketCan documentation

Usage

Reading a frame

using (CanRaw can = new CanRaw())
{
    byte[] buffer = new byte[8];
    // to scope to specific id
    // can.Filter(id);

    while (true)
    {
        if (can.TryReadFrame(buffer, out int frameLength, out CanId id))
        {
            Span<byte> data = new Span<byte>(buffer, 0, frameLength);
            string type = id.ExtendedFrameFormat ? "EFF" : "SFF";
            string dataAsHex = string.Join("", data.ToArray().Select((x) => x.ToString("X2")));
            Console.WriteLine($"Id: 0x{id.Value:X2} [{type}]: {dataAsHex}");
        }
        else
        {
            Console.WriteLine($"Invalid frame received!");
        }
    }
}

Writing a frame

CanId id = new CanId()
{
    Standard = 0x1A // arbitrary id
};

using (CanRaw can = new CanRaw())
{
    byte[][] buffers = new byte[][]
    {
        new byte[8] { 1, 2, 3, 40, 50, 60, 70, 80 },
        new byte[7] { 1, 2, 3, 40, 50, 60, 70 },
        new byte[0] { },
        new byte[1] { 254 },
    };

    while (true)
    {
        foreach (byte[] buffer in buffers)
        {
            can.WriteFrame(buffer, id);
            string dataAsHex = string.Join("", buffer.Select((x) => x.ToString("X2")));
            Console.WriteLine($"Sending: {dataAsHex}");
            Thread.Sleep(1000);
        }
    }
}

Setup for Raspberry PI and MCP2515

• Connect SPI device to regular SPI pins (SI/MOSI - BCM 10; SO/MISO - BCM 9; CLK/SCK - BCM 11; CS - CE0)
• Interrupt pin should be connected to any GPIO pin i.e. BCM 25 (note: interrupt pin can be adjusted below)
• Add following in /boot/config.txt

dtparam=spi=on
dtoverlay=mcp2515-can0,oscillator=8000000,interrupt=25
dtoverlay=spi-bcm2835-overlay

For test run ifconfig -a and check if can0 (or similar) device is on the list.

Now we need to set network bitrate and "start" the network. Other popular bit rates: 10000, 20000, 50000, 100000, 125000, 250000, 500000, 800000, 1000000

sudo ip link set can0 up type can bitrate 125000
sudo ifconfig can0 up

Diagnosing the network (tested on Raspberry Pi)

These steps are not required but might be useful for diagnosing potential issues.

• Install can-utils package (i.e. sudo apt-get install can-utils)

sudo apt-get -y install can-utils

• On first device listen to CAN frames (can be also sent on the same device but ensure separate terminal)

candump can0

• On second device send a packet

cansend can0 01a#11223344AABBCCDD

• On the first device you should see the packet being send by the second device