You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
This issue is still present in the current beta version of this adapter
There is no other (open) issue with the same topic (use the search!)
This issue is not described in the adapter documentation / FAQ (read the docs!)
Shelly device
Shelly Plus Plug S
Shelly firmware version
1.3.3
Protocol
MQTT
The problem
Wird dem Shelly die erste nutzbare IP-Adresse eines Subnetzes zugewiesen (Bsp.: 10.20.0.1 im Netz 10.20.0.0/24), so wird zwar der Objektbaum angelegt, aber nicht vollständig befüllt. Es fehlen u.a. die (korrekten) Values in folgenden Datenpunkten:
*.Relay0.InitialState
*.hostname
Nach Änderung auf eine andere IP (letzte nutzbare IP .254 wurde nicht getestet) sowie Löschen des Objektbaumes wird dieser neu angelegt und auch korrekt befüllt. Nach erneuter Änderung auf .1 sowie erneutem Löschen des Objektbaumes wird dieser zwar erneut angelegt, aber wieder mit fehlenden Values in einzelnen Datenpunkten.
iobroker.current.log (in debug mode!)
No response
Version of nodejs
v20.15.0
Version of ioBroker js-controller
v8.3.1
Version of adapter
v7.0.0
The text was updated successfully, but these errors were encountered:
Das mag durchaus sein, sollte aber in meinen Augen aus Adaptersicht egal sein. Wenn da ein Shelly antwortet, dann bitte mit allen verfügbaren Datenpunkten.
Bzgl. Debug: wird heut Abend angefertigt, hab noch nen ungenutzten Plug entdeckt.
I'm sure that
Shelly device
Shelly Plus Plug S
Shelly firmware version
1.3.3
Protocol
MQTT
The problem
Wird dem Shelly die erste nutzbare IP-Adresse eines Subnetzes zugewiesen (Bsp.: 10.20.0.1 im Netz 10.20.0.0/24), so wird zwar der Objektbaum angelegt, aber nicht vollständig befüllt. Es fehlen u.a. die (korrekten) Values in folgenden Datenpunkten:
Nach Änderung auf eine andere IP (letzte nutzbare IP .254 wurde nicht getestet) sowie Löschen des Objektbaumes wird dieser neu angelegt und auch korrekt befüllt. Nach erneuter Änderung auf .1 sowie erneutem Löschen des Objektbaumes wird dieser zwar erneut angelegt, aber wieder mit fehlenden Values in einzelnen Datenpunkten.
iobroker.current.log (in debug mode!)
No response
Version of nodejs
v20.15.0
Version of ioBroker js-controller
v8.3.1
Version of adapter
v7.0.0
The text was updated successfully, but these errors were encountered: