You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
I may have done something to cause this though, which I'll explain below, but first:
If I scan the default example QR code on the documentation page (i.e. this command: !SI6D1H5!R) my new GP12 records once when moved, but after it stops recording, it doesn't return to the "IMU" display and does not record again if moved.
it does repeatedly record (but, separate problem, it also sets the time again, which is undesirable).
I didn't try the more simple command until after I had run the above one quite a few times, so I don't know if that has somehow caused the non-repeats for the simple command. But I have tried power-cycling and removing the battery without effect.
The text was updated successfully, but these errors were encountered:
I may have done something to cause this though, which I'll explain below, but first:
If I scan the default example QR code on the documentation page (i.e. this command:
!SI6D1H5!R
) my new GP12 records once when moved, but after it stops recording, it doesn't return to the "IMU" display and does not record again if moved.However, if I run this command:
mVr1080p25fW0te0cNsMv0dVoV0D4C0S1W0L02T240305171912oMBASE="EX_240305_BC1F_"!SI3D1H60!R
it does repeatedly record (but, separate problem, it also sets the time again, which is undesirable).
I didn't try the more simple command until after I had run the above one quite a few times, so I don't know if that has somehow caused the non-repeats for the simple command. But I have tried power-cycling and removing the battery without effect.
The text was updated successfully, but these errors were encountered: