External LED

This is a Draft

The current design does not have pin outs for external LEDs. It may be added in a future revision.

Power

Connect a LED to 5v with a resistor rated for your LED.

There are a few options, but none would be considered easy.

Remove the existing PC13 led and solder on your own.

Use an unused pin such as PA3 to connect the a resistor and LED.

NOTE: You will have to modify and re-flash the software to drive this pin instead.

TBD

Important

If you are looking for BlueSCSI v2 documentation please go here: https://github.com/BlueSCSI/BlueSCSI-v2/wiki