Skip to content

Latest commit

 

History

History
32 lines (26 loc) · 2.62 KB

User Guide.md

File metadata and controls

32 lines (26 loc) · 2.62 KB

User Guide -v3.1

General / Sessions Use

The following describes general operation of both the Track Session and Rest in Pits Session timer.

  • Upon start up a boot splash will be shown for 2 seconds.
  • After which the Primary Screen will be shown, detailing the current track session duration in minutes, and the statement Ready. This indicates the timer is ready to start. To start the Track Session or race, Swipe Down.
  • After swiping down,Go will display briefly. If Launch Mode has been activited, Lights will be displayed. The timer will commence upon sufficient acceleration.
  • Upon starting, the Track Session timer count down will be displayed, and immediately commence.
  • At 85% completion of the Track Session the timer display colours will change to highlight progression.
  • At 95% completion of the Track Session the timer display colours will again change, further highlighting progression and final expiry warning.
  • At 100% completion the Track Session timer display colours will change again.
  • Once the Track Session has completed, i.e. >100%, the timer will remain running. The session continues to run to provide visibility of any overrunning. Double Tap to complete/exit. A Double Tap can be used to terminate any running timer.
  • Following termination, a Rest in Pits splash will display, followed by commencement of the Rest in Pits Session timer.
  • Once the Rest in Pits Session is complete, the timer will return to the Primary screen. The Rest in Pits Session can be terminated with a Double Tap.

Configuration / Setup

All settings are stored from session to session while the timer has power. Settings are wiped if power is lost.

Session Duration

It is possible to change the duration of both the Track Session and the Rest in Pits.

  • From the Primary Screen, Swipe Left to edit the Track Session and Swipe Right to edit the Rest in Pits Session.
  • Once in either edit modes, use a Swipe Right to increment the duration and a Swipe Left to decrement the value. Note duration values are predefined as [1, 5, 10, 15, 20, 25, 30, 40, 50, 60] minutes.
  • When the desired duration value is shown Swipe Up to save and return to the Primary Screen

Launch Mode

Launch mode is disabled by default. Launch mode can be enabled by defining a Launch Sensitivity value above zero.

  • From the Primary Screen, Swipe Up to edit Launch Sensitivity.
  • Swipe Left or Right to select an appropriate value greater than zero.
  • Swip UP to save and enable Launch mode