title | description | addedAt | pageClass |
---|---|---|---|
Paul Neuhaus 100.462.31 control via MQTT |
Integrate your Paul Neuhaus 100.462.31 via Zigbee2MQTT with whatever smart home infrastructure you are using without the vendor's bridge or gateway. |
2020-06-10 16:45:59 UTC |
device-page |
Model | 100.462.31 |
Vendor | Paul Neuhaus |
Description | Q-REMOTE |
Exposes | action, action_group, linkquality |
Picture |
You will need a paper clip or similar tool to reset the remote control.
- Turn over the remote (on and off button should always face upwards)
- Slide on the battery cover on the back of the remote downwards. Above the left battery you will see a small hole. This is where the reset button is located.
- Push the bent paper clip into the reset opening (hole) and hold down for more than 5 sec. During this time the led on the front side will blink 4 time. Keep the paper clip pressed!
- The status LED now will blink 10 times very fast. If this happens you can remove the paper clip (right after the first fast blink).
The remote now is reset and pairing process will be started automatically.
How to use device type specific configuration
simulated_brightness
: Simulate a brightness value. If this device provides a brightness_move_up or brightness_move_down action it is possible to specify the update interval and delta. The action_brightness_delta indicates the delta for each interval. Example:
simulated_brightness:
delta: 20 # delta per interval, default = 20
interval: 200 # interval in milliseconds, default = 200
Triggered action (e.g. a button click).
Value can be found in the published state on the action
property.
It's not possible to read (/get
) or write (/set
) this value.
The possible values are: on
, off
, toggle
, brightness_step_up
, brightness_step_down
, color_temperature_move
, color_move
, brightness_stop
, brightness_move_up
, brightness_move_down
, color_loop_set
, enhanced_move_to_hue_and_saturation
, recall_*
, scene_*
.
Group where the action was triggered on.
Value can be found in the published state on the action_group
property.
It's not possible to read (/get
) or write (/set
) this value.
Link quality (signal strength).
Value can be found in the published state on the linkquality
property.
It's not possible to read (/get
) or write (/set
) this value.
The minimal value is 0
and the maximum value is 255
.
The unit of this value is lqi
.