Check out the Preconfigured 3mf Files directory for slicer files that contain all required parts with support and other print settings preconfigured. Just delete the rings that don't apply to your build, select your filament and send the job to your printer. EZ
The entire project is intended for:
- 0.4mm nozzle (Wider should not cause problems)
- 0.2mm layer height (Necessary for some built-in helper features)
- Standard strength (5 wall) profile
- 15% gyroid or crosshatch infill
- Higher infill optional
All parts tested in PLA and PETG
Supports required for:
- PitClamp Mini - Common - Handle
- PitClamp Mini - Base - Standard - Lower
- PitClamp Mini - Common - Upper
- PitClamp Mini - Ring - 57AIM
- PitClamp Mini - Ring - iHSV57
Optional accent color for logo.
Requires AMS, just paint bucket the flush lettering faces:
- 5mm/6mm offsets provide clearance for 4040 extrusion. Fine for 3030 setups as well.
- These are the recommended ring offsets for all setups.
- 0mm/1mm offsets are designed to sit close to 3030 extrusion.
- Only use this offset if you really need things to be compact on 3030 setups. Can have clearance issues if your setup isn't absolutely perfect.
For 42AIM motors
For 57AIM "Gold" motors
For iHSV57 motors.
This ring is two parts but by using some design trickery it prints as one with minimal supports.
Ring snaps into two pieces after removing from printer.
Clasp each half around the motor.