Is the "Grove - Gas Sensor V2(Multichannel)" supported

[ChrisROL]

Hi,

i try to find out, if the second version of the grove multichannel gas sensor is already supported and i just can't find the correct setting.
The first version is supported by switch USE_MGS, but it has different address and sensors to the V2

https://wiki.seeedstudio.com/Grove-Multichannel-Gas-Sensor-V2/

https://wiki.seeedstudio.com/Grove-Multichannel_Gas_Sensor/

Regards
Christian

[Jason2866]

No, it is not supported.

[ChrisROL]

Is there a posibility to integrate it also, or i am the only one who wants to use it?

[barbudor]

so far you are the 1st one
If you are using an ESP32, it should be fairly simple to recode the driver in Berry

[ChrisROL]

I want to use it with a nodemcu and i haven't done any programming in berry.
My professional is programming on siemens PLC and i'm not good in higher level programming language.
The scripting in tasmota is ok for me

[Jason2866]

If "someone" who has the device writes a driver for Tasmota.

[sfromis]

If it is "fairly similar" to the older generation, it might be feasible to extend the same driver to handle both.

[ChrisROL]

I have only seen a library on the manufactur's page.
One for the old and one for v2.