The Altruist Enclosure Improvements 1.0 - 1.1

[ensrationis]

Identified Problems:

• The thin walls of the mounts for sensors (temperature, humidity, noise) break at the base due to the horizontal orientation of 3D-printed layers.
• Printer settings errors: the transition between layers occurs in a high-stress area, causing mounts to break during assembly.
  Interference with proper assembly:
• The internal partition near the SDS sensor air duct obstructs correct hose installation, leading to misalignment during assembly.
• No guiding rails or dedicated mounts for the circuit board and SDS sensor.
• The assembled sensor unit inside the enclosure is loose and misaligned.