Skip to content

Latest commit

 

History

History
98 lines (53 loc) · 2.38 KB

Instructions Device Flash and Setup.md

File metadata and controls

98 lines (53 loc) · 2.38 KB
Raw

Instructions Linear Clock Setup

© Jonathan, Aliki, Nicolas, Astrid & Achim Fischer 2019

Install Windows Driver

  • Open this link

https://github.com/acfischer42/ESP8266/raw/Rheinturmuhr/LinearClock-release/CH341SER_WINDOWS.zip

  • Save to Downloads folder and run (double click)

Write Program to device:

  1. Connect clock to USB port of the PC

  2. Download Firmware: open Link and save to Downloads folder.
    https://github.com/acfischer42/ESP8266/raw/Rheinturmuhr/LinearClock-release/LinearClock.nodemcu.v2.bin

  3. Download Flash Tool: open Link and save to Downloads folder.
    https://github.com/acfischer42/ESP8266/raw/Rheinturmuhr/LinearClock-release/NodeMCU-PyFlasher-4.0-x86.exe

  • Double Click to Run the program
  1. Start Flash Tool:

  1. Click on

, select Auto-select for the serial port

  1. Select Firmware that was downloaded in step 1:

  1. Keep Baud Rate and Flash Mode at default (115200, DIO)

  2. Select erase all

  1. Click on

Unplug from PC and replug or plug into power supply

Configure Device:

  1. Use a PC/Laptop with Wireless adapter or disable Cellular Data on the phone.

  2. Power up the Clock

  3. Connect Wifi on pc/phone to IOT_AP

    1. Password: 12345678

  4. Open browser. Enter address http://192.168.4.1

  5. Click on 2. Configure Wifi

  1. Enter your Network SSID and password.

  2. Click on Connect/Disconnect – Device will reboot and connect to your wireless network.

  3. You are done

  4. If you need to configure a timeserver (normally not needed)

  5. Click on 1. configure Time.

  1. Enter Timezone (https://www.timeanddate.com/worldclock/)

  2. Enter Timeserver = us.pool.ntp.org or other eu. Ap.

  3. Click on Save Timesettings – you get automatically forwarded to the WIFI config page