Config-files and settings for my Home Assistant and smarthome. So that I easily can set it up if I break my SD-card (Again). Or drown my Rpi (Again). Or fry my Hue-hub (Again).
- Raspberry Pi 4
- 5.1V 3A power adapter (Important to use a proper power adapter!)
- Slide case (Be careful not to break your SD-card when sliding it together...)
- Sonoff Zigbee 3.0 USB dongle
- 20 cm USB-extender for Sonoff
- Philips Hue hub
- Futurehome hub V1.0 (Zwave/enocean)
- USB to SATA
- SSD Drive
- Download and install Rasperry Pi imager: https://www.raspberrypi.com/software/
- Run Pi Imager, select OS, Misc utility images, Bootloader, USB Boot. Select SD-card and Write
- Put SD-card in RPi4, power up RPi, wait 30 seconds, remove power, remove SD-card and throw it away
- Connect USB to sata with SDD to computer, run Pi Imager again
- Select OS, Other specific-purpose OS, Home assistants and home automation, Home Assistant, Home Assistant OS 9.4 (RPi 4/400), select SSD and Write.
- Connect USB to sata to RPi USB 3.0-port, power up RPi.
- Go grab a coffee, and the connect to homeassistant.local:8123 and restore backup.
- HACS
- Auto Backup from HACS
- Samba share - Folder with backup-files from Auto backup mounted on computer which syncs to Jottacloud
- Futurehome2mqtt - Expose (some of) the devices in Futurehome to HA
- Connected to Futurehome-hub
- Zigbee2MQTT
- Bridged to Futurehome, se Mosquitto.conf
- Leaf2mqtt - To get battery-status from Nissan Leaf
- Mosquitto broker
- Bridge to Futurehome, broker for Zigbee2MQTT