Rename signal labels to 'Radar signal' to match the portal (disambiguate from WiFi)
Add Speed Correction and Placement page; link from Home + Device Settings Co-Authored-By: Claude Fable 5 <noreply@anthropic.com>
Add Home Assistant integration page Document pointing a device's Data Server at a local Home Assistant webhook: HA-side webhook automation/template sensor (speed + telemetry, and a full speed + saved-photo recipe), how to set the API Base URL on the Wifi Settings tab, a payload field reference, and troubleshooting. Link it from Home. Co-Authored-By: Claude Opus 4.8 (1M context) <noreply@anthropic.com>
Add Device Settings page documenting every Device-tab control The portal's Device tab had no wiki page: power-saver, the speed thresholds, and especially the four proximity/signal photo triggers (Min Signal, Photo Signal, Photo Signal FRONT/REAR) were only described in firmware code comments. Add a Device Settings page covering every control shown on the tab, including a calibration walk-through for the signal thresholds using the Status-tab live Signal reading, and link it from Home and the Setup Guide. Co-Authored-By: Claude Opus 4.8 (1M context) <noreply@anthropic.com>
Setup/Firmware: match the live minispeedcam.com dashboard Align the wiki with the real Cameras dashboard: "Add a device" claim flow ("Enter device claim code" -> "Add device"), naming/location/direction on the camera card, the exact "Camera local IP address" label, the Device ID -> XXXXXX (mDNS/setup-name) tie-in, and the firmware versions shown on the card. Co-Authored-By: Claude Opus 4.8 <noreply@anthropic.com>
Update wiki for per-device identity + OTA (firmware 1.0.x) - Setup Guide: replace the obsolete "Camera ID" provisioning with the new Claim Code flow (device mints its own identity on first boot); add mDNS (minispeedcam-XXXXXX.local) + local-IP ways to reach the device. - Firmware Update: new page documenting web-UI OTA for both ESP32 and STM32 (Check / Install buttons, status line, safety, partition-migration note). - Programming Guide: flesh out the stub into wired-flashing instructions for both MCUs (ESP over USB, STM32 over CH340 serial bootloader) + build token, FW_VERSION, OTA partition migration. - Home: overview + navigation index linking all pages. Co-Authored-By: Claude Opus 4.8 <noreply@anthropic.com>
Updated Aiming Video Stream (markdown)
Created Aiming Video Stream (markdown)
Created Programming Guide (markdown)
Updated Setup Guide (markdown)
Updated Home (markdown)
Created Setup Guide (markdown)
Initial Home page