You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
I want to convert citygml with the pipline:
citygml(lod2)->3dcitydb(pg)->citygml-tiler(building).
which works with two exceptions: The resulting buildings are sometimes well above the official terrian
compared to the official tiles everything is about the hight of one to two floors to high! See image:
The second problem is , that I did want the buildings on ground level, but in a zero altitude.
I the citygml-tiler has an --offset-parameter, but that is not decribed very well. As the current eleveations are much to high.
I tired to set the parameter to ground: which results in the error, that this not of tipe u32. Which is probaly the next problem.
I did set it to -200 (moved it west and perhaps a bid south? and 200 (moved it east and a bit north, perhaps? Therefore I tried --offset 0 --offset 0 --offset -5 as it where a list.
But that still did move everything to the west.
So please can you specify:
how to use the parameter,
how to set it elevation to groundlevel (or correct it)
how to set everything to zero elevation.
The text was updated successfully, but these errors were encountered:
I was able to set everything to ground level and a bit of shifting with: --offset 0.1 0.5 -3.7 the original crs was 25833 the final crs is 4978.
Everything displayed in an instace of the master portal.
Edit: I removed about a thir of the buildings and needed to correct the z-offset to be -5
I want to convert citygml with the pipline:
citygml(lod2)->3dcitydb(pg)->citygml-tiler(building).
which works with two exceptions: The resulting buildings are sometimes well above the official terrian
compared to the official tiles everything is about the hight of one to two floors to high! See image:
The second problem is , that I did want the buildings on ground level, but in a zero altitude.
I the citygml-tiler has an
--offset
-parameter, but that is not decribed very well. As the current eleveations are much to high.I tired to set the parameter to ground: which results in the error, that this not of tipe u32. Which is probaly the next problem.
I did set it to -200 (moved it west and perhaps a bid south? and 200 (moved it east and a bit north, perhaps? Therefore I tried
--offset 0 --offset 0 --offset -5
as it where a list.But that still did move everything to the west.
So please can you specify:
The text was updated successfully, but these errors were encountered: