diff --git a/docs/devices/9290030675.md b/docs/devices/9290030675.md index dc17ccc955b80..4e21705a4c7c3 100644 --- a/docs/devices/9290030675.md +++ b/docs/devices/9290030675.md @@ -30,6 +30,13 @@ pageClass: device-page To initiate setup mode, press and hold the setup button on the rear of the device for 3-5 seconds until the setup light blinks red. It is now in pairing mode. When paired, the light blinks green. Please note that the setup light is below the main sensor. + + ### Occupancy reporting +By default, the sensor will report occupancy at time it is detected, then 5 seconds later, then 10 seconds later, then it will go mute. +If you want to use this sensor for occupancy detection and not for motion (eg: keep a light on as long as you're in the room), you need to tweak the max reporting time which by default is 1h, +and configure the sensor to report occupancy status every 15 seconds or whatever your automation needs. +Go to the Reporting tab and change the "max rep interval" value for the occupancy attribute, then apply the change. +