You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
another topic I stumbeled over when milling the outline of my boards is, I miss holding tabs distributed around the circumference of the board to hold it in place.
Is there a similarly simple trick like with the line thickness?
Harald
The text was updated successfully, but these errors were encountered:
Got it on my own...
It's somewhat teditious but you can draw the line in the milling layer manually interrupted.
If we where in a wish concert, I would wish, you implement this in code :)
Just an idea...
Hi John,
another topic I stumbeled over when milling the outline of my boards is, I miss holding tabs distributed around the circumference of the board to hold it in place.
Is there a similarly simple trick like with the line thickness?
Harald
The text was updated successfully, but these errors were encountered: