TPFanCtrl2 on P1 Gen7

[Yevgeny1]

TPFanCtrl2 works on P1 Gen7, but found 2 non-real sensors, 'pci' (always=1C) and 'pwr'(always=67C), I disabled it.
coolers speed:
Level= 0 0
Level= 1 ~ 2126 / 2186 very silent
Level= 2 ~ 2820 / 2940 moderate-silent
Level= 3 ~ 3240 / 3340 moderate
Level= 4 ~ 3580 / 3690 more than moderate
Level= 5 ~ 3930 / 4040 moderate - loud
Level= 6 ~ 4530 / 4630 loud+
Level= 7 ~ 5090 / 5190 very loud

=====================
pls. clarify, how works 2 hysteresis digit's in config, hystUp & hystDown .
for example,
Level=50 0 3 3
Level=60 1 3 3
Level=70 2 3 3
hystDown - stop when Tnew - Tprev =3C ?
hystUp ?

[FanDjango]

pls. clarify, how works 2 hysteresis digit's in config, hystUp & hystDown .

I think the one delta/hyst value is taken when the temp is going up, the other one is taken if the temperature is going down.

So the upward hysteresis could be different from the downward one.

I don't really use this at all, so you might need to experiment.

[FanDjango]

@Yevgeny1

TPFanCtrl2 works on P1 Gen7

Is that (P1 Gen7) actually a single fan machine?

[Yevgeny1]

" Is that (P1 Gen7) actually a single fan machine?"

dual fan, both correctly monitored and managed.

[FanDjango]

I've added it to the list. Thx for the speed table. My P53 actually has similar speeds (and noise levels).

[FanDjango]

Note V2.3.8 in the releases. Changed the way this hysteresis is handled.