edelay display and recalled sxp file

[owenduffy]

It seems to me that when an .sxp is loaded from the SD card, that the e-delay value shown on the display is not relevant, especially if it is non-zero, and should be hidden whilst displaying a recalled file?

Owen

[DiSlord]

Possible only reset edelay settings on load snp files

[owenduffy]

In understand that you cannot obtain e-delay from the snp file.

But if the VNA had e-delay set to say 1nS and THEN you load a snp file, the display continues to show 1nS... it should be changed to display 0.

Owen

[DiSlord]

When loading, I simply stop the sweep and replace the measured values ​​with the data from the file.
Device don`t know data source and display as before (most easy way display data)

I can reset data modification like delays, Port-Z on load file. This hide display this values

[owenduffy]

I think the best thing is to set all those things that would alter transformation to (50 ohm) defaults.

That way, the screen shots do not contain inconsistent data.

Owen