win10 sync stops in full node

[tianxinya2021]

This morning I found two of my full nodes in win10 sync stopped and farm stopped, one since 9pm last night and the other since 2am this morning, but their plotting is still working. At the same time, two other full nodes are running fun. All four full nodes are on the same wallet, but each has its own internet ip. I tried to click 'force reload', but did not work. I had to quit both and restarted full node, but my pending plots are lost from gui. Is there anyway we can push re-sync without shutting down the full node? Thanks.

[cccat6]

Did you upgrade to 1.1.x?

[tianxinya2021]

The two with sync stopped had 1.1.1 and 1.0.5. Even after restart, the 1.1.1 did not initiate sync after 30 min. I had to re-run 1.0.5, which could sync about 30 min after re-start.

[dorkmo]

you should really only have one full node running per network

[dorkmo]

look at your plot filter to see if you are passing the filter and if you are running up to date with the new blocks.

[tianxinya2021]

Yes, blocks are up to date and I saw sometimes plot passing filters. I have firewall open as well.

[tianxinya2021]

I see the full node is connected to
127.0.0.1 | 8444/8444
I would assume everything is fine then.

[dorkmo]

that 127.0.0.1 is only the connection between your wallet and your node on that computer. that isnt connected to the internet. you should see a long list of like 50 nodes on your connection list

[tianxinya2021]

Yes, there are many connection list on 'full node' page, about 12 of them.
What I listed above is on 'farm' page of advance options 'Your Full Node Connection'.